Thursday, September 26, 2013

Power Factor Measurement

Today, I would like to talk about Power Factor Measurement on Simulink.

When I had to face this problem I found a really interesting block on internet:

After some tests, I found the block ideal to measure power factor correction to displaced waves (not to distorted waves)

I did some modifications to it, but basicaly it works the same way as before. Now, I would like to explain the block:

Power Factor Measurement Block
Inside the block there are the following elements:
Inside Power Factor Measurement Block

The functionality of this block is the following:

The integrator block calculates an integration of '1' until voltage or current go to zero, then the value of the integration starts again (value of each signal). This is calculating the voltage phase offset and the current phase offset in each moment t.





Voltage phase offset and Current phase offset

The last period of the simulation will be the one the block considers. Now the constant of the phase of each signal is known, it is compared and multiplied by 2*pi*f to have the actual phase difference of the signals.

Since

The power factor is measured after cos block is applied to the actual phase difference calculated before.

After all that blocks the power factor for displaced waves is measured.

Finally, I would like to show an example:

Example: PF Measurement of displaced signals
If the output of the example is plotted the dispersion can be seen:

Example: V vs I (displaced waves)**

If we calculate the power factor theoretically:
Theoretical PF Measurement of displaced signals

It can be seen that both results match.



References:
Saurabh Kabdal
Gautam Buddha Technical University (GBTU), U.P, India

Notes:
**Notice that current wave has been multiplied in order to be compared with voltage in the plot

Licencia Creative Commons

5 comments :

  1. Hi, nice post got valuable information about Power factor.
    Power factor improvement plays a major role in the industry, which saves lots of money and strengthens the life of the machine.

    ReplyDelete
  2. hi, this is an excellent post.
    i have just one queston : how much is the gain K ??

    ReplyDelete
  3. hi, this is an excellent post.
    i have just one queston : how much is the gain K ??

    ReplyDelete
  4. Is there any method to measure power factor in distorted wave form (harmonics present in current) using MATLAB simulink.

    ReplyDelete